Create and change programs

About PMs

Copy a PM program

Change a PM program

Remove a unit from a PM

When adding a new PM, the steps are as follows:

1. Define the program.
2. Define the activities for the program
3. Once activities have been defined, you can:
   • Add sub-activities
   • Add PM metrics
   • Add PM parts
   • Add PM skills
   • Add PM activity equipment group standards. Once these have been set up, you can:
   • • Add equipment group procedures
     • Add equipment group skills
     • Add equipment group check lists
4. Identify sub-programs, if applicable
5. Identify the components that are affected by the PM, if applicable
6. Once components have been identified, you can:
   • Override component intervals
   • Override component parts
   • Specify component instances, if applicable. Once these have been set up, you can:
   • • Override component instance intervals
     • Override component instance parts
7. Identify the equipment groups that are covered
8. Once equipment groups have been identified, you can:
   • Override equipment group program intervals
   • Override equipment group parts requirements
   • Specify included equipment units, if not all units of a group will be included. This can be done either through individual groups or through a complete unit listing. Once these have been specified, you can:

   • • Override program intervals for a unit

     • Override program parts requirements for a unit

     • Set up a PM calendar for a unit

9. Change PM rules, if required

10. If using sliding PMs, add PM patterns

11. Once PM patterns have been added, you can:

    • Set up PM pattern activities

    • Set up PM pattern document links