Equipment components

All equipment units are composed of multiple parts, many of which are tracked. Most of these parts will require replacement and/or repair over the life of the unit. All components defined for the equipment group are copied to the unit automatically. However, units might have different or additional components from those of the group.

Note that parts are automatically added to the component list when they are issued to the unit from a work order.

1. At the Asset Management main menu, select Equipment | Equipment. The Display Equipment screen appears.
2. Right-click on the unit and select Action List. The Equipment Actions screen appears.
3. Click Specific Components. The Specific Item Components display screen appears.
4. Click Change . The Specific Item Components change screen appears.
5. Change any values as required.
6. Click Enter to save the changes.
7. Click Add . The Specific Item Components add screen appears.
8. Fill in the fields as required.

   Component Itemis a specific item installed on the unit. You can right-click in the field and select Prompt to select the component from a list.

   Component Serial #is the serial number stamped on the part by its manufacturer, if applicable.

   Locationis the location on the equipment unit where the part has been installed; e.g. LF for left front. You can right-click in the field and select Prompt to select the location from a list.

   Install Dateis the date the component was installed on the unit.

   Removal Dateis the date the component was removed from the unit, if appropriate.

   Facilityis the facility that installed the part. You can right-click in the field and select Prompt to select the facility from a list.

   Deptis the shop or department that installed the part. You can right-click in the field and select Prompt to select the shop from a list.

9. Click Enter to save the components.

Back to Equipment Master